Harbor Freight Tools 91523 - Manual (Page 17)

SKU 91523 PAGE 17
damaged electrical wiring, and any other condition that may affect its safe opera-
tion. If an Engine problem occurs, always have the Engine immediately checked
out by a
qualified service technician before further use.
Do not use damaged equipment.
3. Before each use, check to make sure the Engine’s oil level and gas level is
adequate. If necessary, fill the Engine’s Crankcase until the oil level is even with
the Oil Fill Hole, and fill the fuel tank.
4. Before each use, With a soft brush, cloth, or vacuum, remove all debris from the
Generator. Then, use a premium quality, lightweight machine oil to lubricate all
moving parts.
5. Every 20 hours of use, drain the old Engine oil and replace with approximately
3/4 (0.63) quart of a high quality SAE 10W-30 grade engine oil.
6. Every 300 hours of use, have a qualified, certified technician perform thorough
maintenance on the Generator and its Engine.
7. For long term storage, either drain fuel into a suitable container or add a fuel
preservative/stabilizer (not included) to prevent breakdown of the fuel.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIA-
GRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBU-
TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE
IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY
CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL
RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR RE-
PLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.
INSPECTION, CLEANING, AND MAINTENANCE
1. CAUTION! Always make sure the Engine Power Switch (2) is in its “OFF”
position. Disconnect the spark plug wire from the engine. And allow suffi-
cient time for the Engine and Generator to completely cool before perform-
ing any inspection, maintenance, or cleaning.
2. Before each use, inspect the general condition of the Generator. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,