Harbor Freight Tools 66399 - Manual (Page 7)

Page 7 For technical questions, please call 1-800-444-3353. SKU 66399
8.
Fig. 2
On/Off Switch (25)
Fuse (26)
Flip the On/Off Switch (25) to the “ON”
position. (See Fig. 2.)
Note: Turn unit on before connecting to
tire valve to prevent blowing the fuse.
9. Holding the Air Nozzle Grip (56), thread
the Air Nozzle (55) onto the valve stem
of the item to be inflated, or attach an
alternate Inflator Nozzle (61,62,63).
10. NOTE: When inflating, finger-tighten Air
Nozzle only. Do not over-tighten.
11.
Fig. 3
Monitor the Pressure Gauge carefully to
avoid over-inflating the item. (See Fig. 3,
above.)
12. Continue inflating until the recommended
pressure is reached.
13. Stop the compressor by clicking the On/
Off Switch to its “OFF” position.
14. Remove the Air Nozzle by
unthreading it from the valve stem.
NOTE: In the case of a football or soccer
ball, pull the Needle Nozzle (63), out of
the ball valve orifice.
NOTE: After disconnecting the Compres-
sor, it is advisable to verify tire pressure
with a tire pressure gauge (not included).
NOTE: Remember to replace the valve
cap, where applicable.
15. If the tire pressure is low, repeat the
steps beginning with Step 7.
16. Remove the clamps from the power
source.
WARNING! THE METAL PARTS OF THE
COMPRESSOR AND HOSES WILL
BECOME HOT DURING USE.
17.
Fig. 4
Allow this compressor to cool, then wipe
down and replace into the storage bag
supplied with this unit. (See
Fig. 4.) Note: There is also a small
REV 09f, 09h; 10a; 10d, 10e