HONDA CD Changer - Manual (Page 4)

4 of 10 AII 23268 (0110) © 2001 American Honda Motor Co., Inc - All Rights Reserved.
9. Remove the four expansion clips that fasten the
floor carpet, and fold the carpet down and out of
the way.
Routing the BUS Cable
12. Route the BUS cable above the steering shaft,
and secure it to the vehicle harness with four
short wire ties in the areas shown.
FLOOR
CARPET
(Fold down.)
13. Route the BUS cable down alongside the fuse
box, and secure it to the body panel with one
cushion tape. Secure the BUS cable to the vehicle
harness with the two short wire ties.
(Position the BUS cable
connector flush with
the radio connector.)
EXPANSION
CLIP
EPT SEALER
SHORT
WIRE TIES
RADIO
CONNECTOR
11. Attach a piece of EPT sealer to the dash support
to protect the BUS cable.
HOOD
OPENER
VEHICLE
HARNESS
SHORT
WIRE TIES
STEERING
SHAFT
FUSE BOX
BUS
CABLE
SHORT
WIRE TIES
CUSHION
TAPE
FUSE
BOX
10. Route one end of the BUS cable up under the
dashboard, and out the radio opening. Position the
BUS cable connector alongside the radio
connector; then secure the BUS cable and the
vehicle harness with two short wire ties in the
areas shown.