HONDA CD Changer - Manual (Page 9)

© 2001 American Honda Motor Co., Inc - All Rights Reserved. AII 23268 (0110) 9 of 10
REAR
BRACKET
STUDS
EPT SEALER
EPT
SEALER
6 x 16 mm
WASHER-BOLT
FRONT
BASE
BRACKET REAR BASE
BRACKET
6 x 16 mm
WASHER-BOLT
EPT SEALER
(Cut in half.)
FRONT
BRACKET
STUDS
FLANGE
NUTS
38. Cut one piece of EPT sealer in half. Attach the
halves to the rear clip nuts you installed in step
36.
42. Position the CD changer on the studs extending
from the front and rear base brackets, and install
the four flange nuts. Install the CD changer first
on the front bracket, then the rear bracket.
39. Position the rear base bracket on the clip nuts,
and install two 6 x 16 mm washer-bolts. Tighten
the bolts securely.
40. Position the front base bracket on the clip nuts
and install two 6 x 16 mm washer-bolts. Tighten
the bolts securely. Attach one EPT sealer over
the head of the lower bracket bolt.
41. Push the clip of the vehicle wire harness
removed in step 35 into the hole in the rear base
bracket.
VEHICLE
HARNESS
CLIP
REAR BASE
BRACKET
43. Reinstall the relay that was removed in step 20.
44. Plug the BUS cable connector into the CD
changer.
BUS
CABLE
BOLT (reused)
VEHICLE RELAY
CD CHANGER CONNECTOR
CD CHANGER