HoMedics Shiatsu and Vibration Massaging Cussion MCS300HW - Manual (Page 4)

7 6
Maintenance
To Store
place massager in its box or in a safe, dry, cool place. avoid contact with sharp
edges or pointed objects which might cut or puncture the fabric surface. To
avoid breakage, do not wrap the power cord around the unit.
To Clean
Unplug the unit and allow it to cool before cleaning. Clean only with a soft,
slightly damp sponge. Never allow water or any other liquids to come into
contact with the unit.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene,
glass / furniture polish or paint thinner to clean.
• Do not attempt to repair the foldable shiatsu and Vibration Massaging
Cushion. There are no user serviceable parts. for service, send the unit to
the hoMedics address listed in the warranty section.
This device complies with part 15 of the fCC rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. such modifications
could void the user authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class b digital device, pursuant to part 15 of the fCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
however, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.