HoMedics Shiatsu and Vibration Massaging Cussion MCS300HW - Manual (Page 6)

CON
Demo Button
for a brief demonstration of the features of the shiatsu Massaging Cushion,
press the Demo button. The unit will briefly go through each function. Once
complete, the unit automatically turns off. The l.E.D. light will blink to indicate the
active functions.
Shiatsu Massage
shiatsu is a deep kneading circular massage. This unit features a massage
mechanism that travels up and down the back of the cushion.
Vibration Massage
add invigorating vibration massage to any shiatsu massage program.
Heat Button
for soothing heat when
massage is on, simply
press the heat button
and the corresponding
red l.E.D. light will
illuminate. To deselect,
press the button again
and the corresponding
l.E.D. light will turn off.
for your safety, heat
cannot be turned
on if massage is not
selected.
Power Button
To turn on the massage
functions, first press
the pOWEr button.
The l.E.D. indicator will
illuminate and confirm
your selection. To
turn off the massage
functions, simply press
the button again. The
l.E.D. indicator will
blink while the shiatsu
massage mechanism
returns to its lowest point
and then it will turn off.
10 11
NOTE: When
“POWER” button
is pressed for
first-time use, the
moving shiatsu
mechanism will
automatically
move to the lowest
position before
starting a massage
program. After initial
use, mechanism
will always park
at lowest position.
See note below
regarding parking.
NOTE: The moving
Shiatsu massage
mechanism always
“parks” or finishes
in its lowest
position. It will
continue to this
position after the
power has been
turned off. If the
electrical supply is
interrupted, when
power is restored,
the mechanism will
“park” or move to
its lowest position.
Moving Shiatsu
massage mechanism
The actual product materials and fabrics
may vary from the picture shown.
Shiatsu and Vibration
Massaging Cushion
Moving Massage Mechanism
Shiatsu Massage
program buttons
Zone buttons cause the moving shiatsu massage
mechanism to target specific areas of the back:
Full Back
The shiatsu massage mechanism travels up and
down the back.
Upper Back
The shiatsu massage mechanism focuses from the
mid to upper back.
Lower Back
The shiatsu mechanism focuses from the mid to
lower back.
To select a massage area, simply press the button
and the corresponding l.E.D. light will illuminate.
To deselect, simply press the button again and the
corresponding l.E.D. light will turn off.
NOTE: There is a 15-minute auto shut off on
the unit for your safety.