Hand Held Products IT4800 - Manual (Page 28)

2 - 4
Scan Data Window
Once successful communication has been established, you can scan codes and
display the bar code data in a window. Select View - Scan Data Window.
As you scan bar codes, the data appears in the Serial Scan Data Window.
You can alter the font in this window by using the Font button, or clear all data in
the window with the Clear button.
If you wish to see the mnemonic for any embedded control characters, you
should put a check in the checkbox for Expand Control Chars (the default
setting). If you wish to see the ASCII control character rather than the mnemonic,
turn off this checkbox.
Note: The ASCII control character that is displayed is dependent on the font you
are using.