Humminbird 1157C - Manual (Page 25)

7. Insert cable connectors into the proper recesses on the cable collector insert. The cable
connectors are keyed to prevent reverse installation, so be careful not to force the connectors into
the wrong slots. If you don’t have a cable for every hole in the insert, install the blank plugs to
protect the control head from the weather.
8. Line up the cable collector insert and cover, with the keying feature, then slide the cover into
place on the insert.
9. Attach the cable collector insert to the cable collector cover using the (2) #6 Phillips screws
provided.
10. Plug the assembled cable collector into the back of the control head, pushing gently but steadily
until you feel the collector snap into place. Cable connectors and cable sockets are keyed to
prevent reverse installation, so be careful not to force the connectors into the wrong sockets.
Transducer
Cable Collector Cover
4
5
Cable Collector Insert 6
Inserting the Cables into the Cable Connector Insert
1 2
3 4 Power
Communications
1
2
Temp/Speed 3
5
6
Cable Collector Insert 1
Screws 2
Cable Collector Cover 3
Assembling the Cable Collector
3
1
2
15