Harbor Freight Tools Predator Generator 69728 - Manual (Page 8)

Item 69728 / 69729 Page 8
For Pump technical questions, please call 1-800-444-3353.
For engine technical questions, please call 1-800-520-0882.
Sa
Fet
Y
O
Pe
R
ati
O
n
m
aintenan
C
e
Setu
P
initial tool Set up/assembly
Read the entiRe imPORtant
SaFetY inFORmatiOn section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
tO PRevent SeRiOuS injuRY:
Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that
can start fires around dry vegetation.
a spark arrestor may be required.
The operator should contact local fire
agencies for laws or regulations relating
to fire prevention requirements.
At high altitudes, the engine’s carburetor, governor,
and any other parts that control the fuel-air ratio will
need to be adjusted by a qualified mechanic to allow
efficient high-altitude use and to prevent damage to the
engine and any other devices used with this product.
CautiOn: This generator is not intended to power
sensitive electronic equipment without the addition of an
appropriate line conditioner and surge protector (both not
included). Sensitive electronic equipment includes,
but is not limited to, audio/video equipment, some
television sets, computers, and printers. Sensitive
electronic equipment should be operated on approved
inverter type generators or pure sine wave generators.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
note: Wheel Kit, item # 68531 (sold separately) can be used with this generator.
Grounding
The Generator must be properly grounded before
use. Have the unit grounded by a qualified
electrician if you are not qualified to do so.
To ground the Generator, connect a #6 AWG
grounding wire (not included) from the Grounding
Terminal on the Control Panel to a grounding rod
(not included) that has been driven at least 24
inches deep into the earth. The grounding rod must
be an earth-driven copper or brass rod (electrode)
which can adequately ground the Generator.
Operating instructions
Read the entiRe imPORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
inspect tool before use, looking for damaged, loose, and missing parts.
if any problems are found, do not use tool until repaired.
Generator Pre-Start Checks
Inspect engine and equipment, looking for
damaged, loose, and missing parts before set
up and starting. If any problems are found,
do not use equipment until fixed properly.
Checking and Filling engine Oil
CautiOn! Your Warranty is vOiD if the engine’s
crankcase is not properly filled with oil before each
use.
Before each use, check the oil level. Do not run the
engine with low or no engine oil.
Running the engine with no or low engine oil
Will permanently damage the engine.
1. Make sure the engine is stopped and is level.
2. Close the Fuel Valve.
3. Clean the top of the Dipstick and the area around it.
Remove the Dipstick by threading it counterclockwise,
and wipe it off with a clean lint free rag.
4.
Full level
Full level
Reinsert the Dipstick without threading it in and
remove it to check the oil level. The oil level
should be up to the full level as shown above.