Hitachi Koki USA CMP4120HDUS - Manual (Page 18)

ENGLISH
9
OPERATING INSTRUCTIONS
•
When the indicating lamp blinks in green or the message
“POWER SAVE” or “OUT OF FREQUENCY” appears on
the screen, there is something unusual about the status of
reception. See “Symptoms That Seemingly Appear to be
Failures.”
■ To turn on the main unit power supply, main unit the MAIN POWER switch ( )
of the main unit to ON and then press the SUB POWER button or the POWER
button of the remote controller.
■ To turn off the main unit power supply, press the SUB POWER button of the main
unit or the POWER button of the remote controller, then set the MAIN POWER
switch ( ) to OFF.
•
For normal operations, leave the main power switch ( ) set to ON and use the sub power
switch or the Power button of the remote controller to turn the power on and off.
POWER
Main power
switch
Main unit Remote
controller
SUB-POWER
Turning Power On and Off
Indicating lamp Power status Operating
Off Off
When the main power switch is set to
OFF.
Lights red
Off
(standby)
When the main power switch is set to
ON and Power button of the remote
controller or the sub power button on the
control panel located at the front part of
the bottom plate is off.
Lights or blinks
green
On
When the main power switch is set to
ON and Power button of the remote
controller or the sub power button on the
control panel located at the front part of
the bottom plate is on.
23
TIPS
• Avoid repeatedly turning the monitor on and off at short time
intervals.
• Failures might result from such operation.
• Turn off the main power switch ( ) before leaving the monitor out
of use for an extended period of time.
• If a power failure occurs while the main unit is running, it would be
powered on upon recovery from the failure. Turn off the unit main
power switch before leaving the main unit.