haier FCD-JTSA50-III - Manual (Page 6)

8 5
Setting Environment Installation
6
Description of the Symbols
Do not set it at place where is too cold and
may freeze. Do not set at outdoor places
Do not use as floorstanding appliance Please mount it to firm and reliable wall
Do not install to places without sewer
In case connecting water heater with water drain hose,
connect the drain hose to the inlet of the sewer to
avoid polluting by splashing.
The original pipeline of the water heater is an organic part of "PTO¢ñ 0". Do not remove it by yourself.
Otherwise we will not take responsibility for the injure and loss caused by the safety trouble occurred therefrom.
Never do that
Be sure to act as per instructions
Be sure to have it installed by installation staff of the after service
department, or the appointed staff. It adopts wall-mounting installation.
Make four holes with diameter of 12mm and depth 65mm with churn drill on
the wall as per the installation dimension drawing. Insert the bolts into the
holes. Then lift the water heater, set the wall-mounting rack on the bolt. Set
the gasket and fasten the nut. Install the accessories including safety valve
etc. as indicated in Figure 2. Remember to seal with rubber tape to avoid
water leakage.
The hot water pipe shall not be too long to reduce the heat losses.
Please reserve some space in installation for the future maintenance.
To facilitate the installation and dismantling, it is suggested to add G 1/2'
flexible nut at the suitable position of the water inlet and outlet pipe
separately. Confirm the position needing water supply. Connect the water
inlet/outlet pipe and tap water pipe to the position respectively.
Cold water inlet
Mixing valve
Hot water
outlet valve Cold water
outlet valve
Shower nozzle
(Figuie 2) for reference in installation only
Hot
water
outlet
Safety valve