HONDA WMP20X - Manual (Page 5)

5
NOTICE
Pumping liquids that are not listed may cause damage to the pump.
Agricultural Chemicals
Industrial Chemicals
PUMP PERFORMANCE
The maximum pump discharge capacity is determined when pumping
clear water at 0 ft (0 meters) total head and at sea level. As the total
head (discharge head + suction head) increases, pump discharge
capacity decreases (see figure). If the pump is used at higher
elevations, pump discharge capacity may also decrease. Other
factors affecting pump discharge capacity are:
• The type of chemical being pumped.
• The length and type of the suction and discharge hose used.
Oil Alert ® System
The Oil Alert system is designed to prevent engine damage caused by
insufficient oil in the crankcase. Before the oil level in the crankcase
can fall below a safe limit, the Oil Alert system will automatically shut
down the engine (the ignition switch will remain in the ON position).
If the engine stops and will not restart, check the oil level (page 8)
before troubleshooting in other areas.
Aatrex Dual N-Serve 24
Amiben Eradicane Phosphoric Acid
Solutions
Ammonium
Thiosulfate Extrazine Poly-N
Banvel Larsban Ranger
Basagran Lasso Round-up
Bicep URAN Solutions Sutan
Bladex Modown Treflan
Vernam
Acetic Acid, 20% Glycerine (Glycerol) Sodium Acetate
Aluminum Sulfate Lactic Acid Sodium Bicarbonate
Ammonium Nitrate Lead Acetate Sodium Bisulfate
Ammonium Sulfate Magnesium Chloride Sodium Bisulfite
Barium Sulfate Magnesium Nitrate Sodium Carbonate,
10%
Borax (Sodium Borate) Magnesium Sulfate Sodium Chlorate
* Calcium Chloride Maleic Acid Sodium Chloride
Citric Acid Nickel Chloride Sodium Nitrate
Copper Sulfate Nickel Sulfate Sodium Silicate
Detergents (General) Oleic Acid Sodium Sulfate
Ethylene Glycol Phosphoric Acid,
0-80% Stearic Acid
Fatty Acids Potassium Carbonate Sulfuric Acid, 0-29%
Ferric Nitrate Potassium Chloride Tartaric Acid
Ferric Sulfate Potassium Nitrate Vinegar
Ferrous Sulfate Potassium Sulfate Water (Clear)
Formaldehyde, 40% Soaps (neutral) Water (Salt)
Zinc Sulfate
* Temperature does not exceed 80°F.
The temperature operating range of the pump is between
20 ~ 130°F (-7 ~ 54°C).
Pump Performance (Maximum with clear water)
Total head 105 ft (32 m)
Suction head 26 ft (8 m)
Discharge capacity 220 gal/min (833
/min)
Self-priming time 65 sec at 16.4 ft (5 m)
Pressure 45 psi (310 kPa)
DISCHARGE
HEAD
SUCTION
HEAD
TOTAL
HEAD
POM50594-G_WMP20X.fm Page 5 Tuesday, March 25, 2008 2:34 PM