Harman-Kardon HD720 - Manual (Page 17)

Programmed Play Operation
14
To remove tracks from the middle of a
previously programmed sequence, press
the
Check @ o button, and then
press the Skip buttons 8 h until the
desired track number appears in the dis-
play. Press the
Clear e or Stop/Clear
5 button to remove the track from the
sequence.
Repeat Programmed Play
The HD720’s programming system
enables you to repeat either a single
track, the entire disc or a specially
programmed passage that you select.
Repeat All
To repeat all of the tracks on a disc, press
the
Repeat 1/All button f or the
Repeat button $ once until the
REPEAT and ALL indicators light up.
When you see these indicators, the entire
disc will play through to the end, and
then start again from the beginning. The
disc will play continually until the
Stop
button 5 k is pressed.
Repeat One
To repeat the track in play, press the
Repeat 1/All button f or the Repeat
button $ twice. The REPEAT and ONE
indicators will light and the track will
continue to play over and over again
continuously. If the track is changed by
pressing the
Skip buttons 8 h while
the Repeat function is in use, the newly
selected track will be repeated. To stop
the repeat play, press the
Stop button 5
k or press the Repeat button $ f
until the REPEAT indicator goes out.
Repeat A–B
The HD720 may be programmed to
repeat any section within a track, or a
complete passage or program that
includes material in a series of tracks.
To program the unit for A–B play, first
locate the point on the disc where you
wish to begin the repeated section. At that
point, press the
Repeat A–B button
g . The REPEAT and A indicators will
light in the Information Display to
show that the program process has start-
ed. Let the disc continue to play until you
have reached the end of the section to be
repeated. When the end point is reached,
press the
Repeat A–B button g
again. Note that the REPEAT and A–B
indicators will now be illuminated.
Once the Repeat A–B button g is
pressed for the second time to complete
the programming, the HD720 will auto-
matically go to the start of the selected
passage and continue to play the section
over and over.
To resume normal play press the Repeat
A–B button g again. The REPEAT and
A–B indicators will go out, and the rest of
the disc will play normally.
Auto Play
The HD720 may be programmed to auto-
matically go into the play mode when
the unit is turned on.
To use this feature, insert a disc in the
drawer and close the drawer as explained
on page 10. Next, locate the
Autoplay
switch £ on the rear panel. Place the
switch in the ON position and then either
turn the unit off by pressing the front
panel
Power Switch 1 until the
Statue Mode Indicator 2 goes dark,
or place the unit in the Standby mode by
pressing the
Power Off button a on the
remote.
When the HD720 is turned on using
either the
Power Switch 1 or the
Power On button b the unit will
automatically go into the Play mode and
the disc will play through from the first
track to the last.
To return the unit to normal operation,
put the
Autoplay switch £ in the OFF
position.
HD720 –120V Owner's Manual 9/17/98 9:54 AM Page 14