Haan SV-60 - Manual (Page 13)

Fig 11
see sweating on the surface of the Resting Mat and
steam being emitted from the bottom of the SV-60.
12) Place an Ultra-MicroFiber Pad on the floor with the
hook and loop side facing up and the microfiber
side down. Once the SV-60 has heated up, lift it
off the Resting Mat and place it on top of the
Ultra-Micro-Fiber™ Pad. (Fig 11)
13) Move the SV-60 over the floor in a back and forth
motion sanitizing your floor with steam. The
super-absorbent pad soaks up the moisture
leaving your floors dry to the touch. (Fig 12)
Haan
®
Helpful Hints:
To use the Pad Tray and ultra-MicroFiber™ Pad
most effectively:
• Be sure to align the Pad Tray on the base of the
unit with the center of the Ultra-MicroFiber™ pad
when affixing the pad. Notice the blue center strip
on the attachment side of the pad; this strip should
line up with the opening for the steam jets. (Fig 13)
• Be sure not to block the suction/agitator brush
opening. Blocking the opening could result in the
weakening of suction. (Fig 14)
• For initial steam generation, place the unit on the
Resting Mat before attaching the Ultra-MicroFiber™
Pad. During initial heating cycle the heated water
may cause condensation which could soak your pad.
Once the unit has built-up the steam needed to
effectively sanitize, place the unit on a dry pad to
absorb the moisture as you use it to clean the floor.
• After affixing the cleaning pad, make sure to place
the SV-60 on the floor protector pad between uses,
or while cooling, to protect your floor. Never leave
the Steam Vacuum in one spot on any surface for
any period of time.
• Push and pull the unit slowly across the floor to
thoroughly clean each section.
• DO NOT place too much force on the pole when
pushing the unit, whether on the carpet or hard
surfaces. The SV-60 will glide across your floor
more easily if you lower the angle of your pole.
Operating Instructions:
(cont)
Fig 12
Fig 13
Correct Pad
Placement
www. HAANUSA.com 877-HAAN DIRECT / 877-422-6347 pg 11
Steam Jets
Vacuum Area
Clear
Fig 14
WRONG Pad
Placement
Vacuum Area
Covered
WRONG Pad
Placement
Pad Not
Centered