Hitachi DVP305U - Manual (Page 34)

Setting Up the Audio Options
1
Press the SETUP button when in stop mode.
2
Use the UP/DOWN button to select Audio Options. Then press the ENTER button.
3
Use the UP/DOWN button to select the desired item. Then press the LEFT/RIGHT button.
(1) DIGITAL OUTPUT
PCM : Converts to PCM(2CH) 48kHz/16bit audio.
Select PCM when using 3D sound.
BITSTREAM : Converts to Dolby Digital BITSTREAM (5.1CH).
Select BITSTREAM when using the Dolby Digital Audio Output.
NOTE : Be sure to select the correct Digital Output.
(2) DTS
ON : Outputs DTS BITSTREAM via digital output only. Select DTS
when connecting to a DTS DECODER.
OFF : Doesn't output DTS signal.
(3) DYNAMIC COMPRESSION
ON : To select dynamic compression.
OFF : To select the standard range.
(4) 2X SCAN AUDIO
ON : Turns 2X audio on.
OFF : Turns 2X audio off.
Though 2X SCAN AUDIO is ON in the Setup Menu, no sound will be heard on
discs which are recorded with LPCM, DTS or MPEG-Audio.
NOTE
- If the selected language is not recorded on the disc, the original pre-recorded language is selected.
- How to make the Current Menu disappear and return to Setup Menu during set UP;
Press RETURN button.