Harbor Freight Tools 92386 - Manual (Page 14)

SKU 92386 for technical questions, please call 1-800-444-3353. Page 14
OperATINg INSTrucTIONS
Note: The Rail Stand (41) of the Tile Saw is held in place by the packaging during
shipment. Always tighten the butterfly Knob to lock the rail Stand prior to
performing maintenance or moving the Tile Saw to another location.
(See figure H.)
buTTerfly KNOb
(42)
rAIl STAND
(41)
eND VIeW
fIgure H
To Fill And Drain The Water Tray:
Fill the Water Tray (67) with enough clean, cold water so that the Water Pump (7)
is about 3/4 submerged, but not so much water that the Water Tray overflows.
(See figure I, next page.)
NOTe: To prevent excessive wear on the Saw Blade (4), make sure to maintain a
continuous flow of water over the entire Saw Blade while cutting. Never cut anything
if the water flow is not continuous.
To drain the Water Tray (67), remove the Drain Plug (69) located at the bottom of
the Water Tray. Once drained, replace the Drain Plug.
NOTe: You may also pull out
the Water Tray from the Tile Saw and pour out the water. (See figure I.)
1.
2.
3.
reV 09/06