Notice, Personal safety, Tool use and care – Harbor Freight Tools CENTRAL PNEUMATIC 94572 User Manual
Page 3: Service
Page 3
For technical questions, please call 1-800-444-3353.
Item 94572
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Spray Gun.
SAFETY
Op
ERA
TION
M
AINTENANCE
SETU
p
personal Safety
a.
Stay alert. Watch what you are
doing and use common sense when
operating the tool. Do not use the
tool while tired or under the influence
of drugs, alcohol, or medication.
A moment of inattention while operating the
tool increases the risk of injury to persons.
b.
Dress properly. Do not wear loose clothing
or jewelry. Contain long hair.
Keep hair, clothing, and gloves away
from moving parts. Loose clothes, jewelry, or
long hair increases the risk of injury to persons
as a result of being caught in moving parts.
c.
Do not overreach. Keep proper
footing and balance at all times.
Proper footing and balance enables better
control of the tool in unexpected situations.
d.
Use safety equipment.
Wear heavy-duty work gloves and
a NIOSH-approved respirator
during use. Non-skid safety shoes
and a hard hat must be used for the
applicable conditions.
e.
Always wear eye protection.
Wear ANSI-approved
safety goggles.
Tool Use and Care
a.
Do not force the tool. Use the correct
tool for the application. The correct tool
will do the job better and safer at the
rate for which the tool is designed.
b.
Disconnect the tool from the air source
before making any adjustments,
changing accessories, or storing the tool.
Such preventive safety measures reduce
the risk of starting the tool unintentionally.
Turn off and detach the air supply, safely
discharge any residual air pressure, and
release the throttle and/or turn the switch to
its off position before leaving the work area.
c.
Store the tool when it is idle out of reach
of children and other untrained persons.
A tool is dangerous in the hands
of untrained users.
d.
Check for misalignment or binding of
moving parts, breakage of parts, and any
other condition that affects the tool’s
operation. If damaged, have the tool serviced
before using. Many accidents are caused
by poorly maintained tools. There is a risk
of bursting if the tool is damaged.
e.
Use only accessories that are identified
by the manufacturer for the specific
tool model. Use of an accessory not
intended for use with the specific tool model,
increases the risk of injury to persons.
Service
a.
Tool service must be performed only
by qualified repair personnel.
b.
When servicing a tool, use only
identical replacement parts.
Use only authorized parts.
c.
Use only lubricants supplied with the
tool or specified by the manufacturer.