HP LTN1565 - Manual (Page 12)

2.2
Connecting Cable TV
To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
1
Plug the incoming cable
into the TV ANTENNA
antenna terminal on
back of the TV.
¥ Because this TV is
cable-ready, you do not need a
cable box to view unscrambled
cable channels.
2
Plug the combiner into
the TV ANTENNA
terminal on the bottom
of the rear panel.
I N S TA L L AT I O N
Antennas with 75-ohm Round Leads
1
Plug the antenna lead
into the TV ANTENNA
terminal on the bottom
of the back panel.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must
combine the two antenna signals before connecting the antennas to the TV.
This procedure requires an optional combiner-adaptor (available at most electronics shops).
1
Connect both antenna
leads to the combiner.
06-CHAPTER 2_en 2/25/03 9:22 AM Page 2