HP 3000CP - Manual (Page 285)

Front-Panel Messages
Message Explanations and Actions
12-3
Check
■■*■
Close right door
The printer has detected an error in the printhead cleaners indicated by the stars.
Reseat (do not replace) the indicated cleaners. When you have done so, close the
right door of the printer. See 11-39, Checking the Printhead Cleaners.
Check ink cartridges
■■❏■ Abort → The printer has detected an error in the cartridges indicated by the empty squares.
Reseat (do not replace) the indicated cartridges or press the
↓ key to terminate the
procedure. In this case, you will not be able to print, and you may later resume
checking the ink system by pressing the Replace Ink System button. See 11-40,
Checking the Ink Cartridges.
Check ink system
→
Ignore
→
After an error has been detected in the ink system, you are given the chance to check
it.
Press
↑ to check the ink system right now. The printer will indicate which ink systems
are affected.
Press
↓ to ignore the error and continue printing. In this case the image quality
cannot be assured.
To fix any errors, see the check-lists in 11-38, Checking Ink Systems.
Check printheads
■■❏■ Abort → The printer has detected an error in the printheads indicated by the empty squares.
The printhead can be replaced, but you should replace all components of the failing
ink systems as soon as possible.
Reseat (do not replace) the indicated printheads or press the
↓ key to terminate the
procedure. In this case, you will not be able to print, and you may later resume
checking the ink system by pressing the Replace Ink System button. (If you have
persistent problems, see
If You Have Problems Reseating a Printhead 11-41 .)
Close left door to
continue You opened the left door while the printer was busy, or you have finished installing
the ink cartridges.
Close the left door to continue.
Close roll cover
Continue
→
Rewind the media to take up any slack in the roll, close the roll cover, then press
↓ to
continue.
Close window to
continue You have finished installing the printheads.
Close the window to continue.
Create pattern
→
Measure pattern
→
Press
↑ to create the pattern for automatic calibration.
Press
↓ to measure the pattern for automatic calibration.
Message Explanation and Action