Hughes WARP7 - Manual (Page 8)

FOOTSWITCH: Jack designed to take a standard
footswitch (the HUGHES & KETTNER ® FS-1 will do
nicely) for switching back and forth between the
CLEAN and WARP channels. To do this, the
CHANNEL SELECT switch on the front panel must
be set to CLEAN (red LED does not light up).
PHONES: Connect headphones to this jack.
The head’s SPEAKER OUT is automatically
disconnected when you insert a plug into this jack.
On the combo, both the SPEAKER OUT and
internal speaker are disabled, ensuring
conciliatory relationships with landlords.
REAR PANEL:
MAINS: Connect the included Euro norm mains
cable to this socket. Before you plug in the mains
cord, ensure your local mains voltage matches
the specification indicated on the device.
SPEAKER OUTPUTS:
Serial (combo): Designed to connect an auxiliary
cabinet with a minimum impedance of 4 ohms.
Unless of course you want to use the WARP 7™
one last time as a hot air grill, barbecuing it in the
process. That’s an option we can’t advocate...
Parallel (heads): Designed to connect to the
included 4x12" cabinet and another auxiliary
cabinet with a rating of at least 8 ohms. The
minimum permissible impedance is 4 ohms. This
means if you connect cabinets to both outs, each
cabinet’s impedance may be no lower than
4 ohms! Unless of course…(see above)
3.0 STANDARD SETUP /
CABLE CONNECTIONS
HEAD/COMBO:
4.0 OPERATING THE WARP 7™
Now that you know a bit about the key features,
let’s take a look at how the WARP 7™ handles. This
section also provides useful tips on connecting the
WARP 7™ to other devices.
4.1 SELECTING CHANNELS
You can activate the channels of the WARP 7™
via the front panel CHANNEL SELECT button or an
external footswitch. The HUGHES & KETTNER ® range
of accessories offers a footswitch that fits the bill,
the FS 1.
4.2 THE WARP 7™ AND FX DEVICES
WARP 7™ is equipped with a serial effects loop.
This means that the preamp output signal is routed
through an inserted effect device in its entirety,
and that the entire signal is processed. Please
note that the sound quality of the processed
signal depends largely on the quality of the
employed effect device. A sorry signal processor
can corrupt your tone.
WARP 7 - MANUAL
8 8
FUSE
SPEAKER OUTS 100 WATTS 4 - 8 OHMS
SPEAKER OUTS
100 WATTS
4 - 8 OHMS
Head version Combo version
Warp_7 Manual 2.5 11.09.2002 10:17 Uhr Seite 8