Hitachi SV 13YA - Manual (Page 11)

English
11
6. Installing the sanding paper
Since the attachment is a hook-and-loop
type, the sanding paper can be installed
easily by just pressing it onto the pad. When
installing the sanding paper, in order to
match it to the holes in the pad, gently fold
it along the axis of two holes as shown in
Fig. 3.
Next, use the holes along the fold as a guide
to match the sanding paper and the pad.
Finally, press the entire sanding paper
uniformly onto the pad.
7. Attaching and removing the dust bag
(1) Attaching the dust bag
As shown in Fig. 4, hold the dust gate and
push it in the direction of arrow A to attach
it to the dust outlet.
(2) Removing the dust bag
As shown in Fig. 4, hold the dust gate and
pull it in the direction of arrow B to remove
it from the dust outlet.
8. Adjustment of speed (SV13YA only)
The SV13YA is equipped with the electric
control circuit which enables non-step speed
control. To adjust the speed, turn the dial
shown in Fig. 5. When the dial is set to “1”,
the sander operates at the minimum speed
(7,000/min). When the dial set to “6”, the
sander operates at the maximum speed
(12,000/min). Adjust the speed according to
the material to be cut and working efficiency.
Fig. 5
Fig. 3
Sanding paper
Pad
Fig. 4
Dust gate
Dust outlet
Dust bag
B
A
Dial