Hitachi SV 13YA - Manual (Page 13)

English
13
3. Switching the sander ON and OFF
The power can be turned on by setting the
lever to ON (1) and turned off by setting the
lever to OFF (0).
NOTE:
Never turn the power switch ON when the sander is contacting the surface to be sanded.
This is necessary to preclude damage to the material. The same applies when switching
the power OFF.
CAUTION:
ⅷ lmmediately after use, always turn the sander off and unplug it.
ⅷ Since the sander may suck in dust and debris, be careful not to place it where there is
much dust and debris when it is still spinning right after use.
HOW TO INSTALL THE OPTIONAL ACCESSORIES
WARNING:
Be sure to switch power OFF and disconnect the plug to avoid
accidents.
⅜ Mounting the polyester buff
Since the attachment is a hook-and-loop
type as with the sanding paper, the
polyester buff can be mounted by just
pressing it onto the pad (Fig. 9).
Fig. 8
Fig. 9
Polyester buff