Harbor Freight Tools 94164 - Manual (Page 9)

For technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
Page 9 SKU 94164
Use only correct gas shielding equipment designed specifically for the type of •
welding you will do. Maintain this equipment properly.
Always protect gas cylinders from heat, being struck, physical damage, slag,
•
flames, sparks, and arcs.
Always use proper procedures to move cylinders.
•
Use the right tool for the job. Do not attempt to force small equipment to do the work
17.
of larger industrial equipment. There are certain applications for which this Welder
was designed. It will do the job better and more safely at the rate for which it was
intended. Do not modify this Welder, and do not use this Welder for a purpose for
which it was not intended.
18. WARNING! People with pacemakers should consult their physician(s) before
using this product. Electromagnetic fields in close proximity to a heart pacemaker
could cause interference to or failure of the pacemaker.
19. WARNING! The warnings and cautions discussed in this manual cannot cover
all possible conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
20. WARNING! This product, when used for welding and similar applications,
produces chemicals known to the State of California to cause cancer and birth
defects (or other reproductive harm).
(California Health & Safety Code § 25249.5, et seq.)
SAVE thESE InStRUCtIOnS
GROUnDInG
nOtE:
this Welder requires the installation of a 3-prong, 220 VAC, polarized,
twistlock power Cord plug (not included).
NEMA configuration # L6-30 or equivalent
The Plug must be installed by a certified electrician.
WARnInG!
Improperly connecting the grounding wire can result in the risk of electric
shock. Check with a qualified electrician if you are in doubt as to whether
the outlet is properly grounded. Do not modify the power cord plug used
with the tool. never remove the grounding prong from the plug. Do not
use the tool if the power cord or plug is damaged. If damaged, have it
repaired by a service facility before use. If the plug will not fit the outlet,
have a proper outlet installed by a qualified electrician.