Harbor Freight Tools 97181 - Manual (Page 7)

Page 7 For technical questions, please call 1-800-444-3353. Item 97181
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Mounting Fence Mounting Fence
1. The Fence (63) fits across the top of the
sanding belt to prevent workpiece from
moving to the rear when sanding.
2. Align two Tabs on the Fence (63) with two
Holes on the top of the Belt End Guard (58).
Place Fence tabs underneath the
Belt End Guard (58). Insert two Machine Screws
through Flat Washers and into Holes. Thread
Machine Screws into the Tabs on the Fence (63).
Note: Use Flat Washers between screw heads
and Belt End Guard (58). See Figure c.
3. Bolt the Fence (63) to the
Belt Support Housing (52) using Bolt (32),
Flat Washer (26), and Lock Washer (27).
Figure c
Fence (63)
Tabs (not shown) are underneath Belt End Guard (58)
where Machine Screws are shown.
Machine Screws
Functions
Switch with
Safety Key
Supporting
Shaft
Angle Adjusting
Knob
Table
Miter Gauge
Sanding Belt
Sanding
Disc
Fence
Belt Tension
Handle
Belt
Alignment
Knob
Sanding Sanding
Sanding Belt
Figure D
Safety Switch Safety Switch
Insert the Safety Key into the Switch. This “Key” is a safety precaution and should remain in the Switch during use
and be removed after Switch (31) is turned off and/or any time the Belt/Disc Sander is left unattended or in storage.