Tool set up, Safet y op era tion m aintenan c e setu p – Harbor Freight Tools 97181 User Manual
Page 8
Page 8
For technical questions, please call 1-800-444-3353.
Item 97181
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION
yy
section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy
REVENT SERIOUS INJUR
REVENT SERIOUS INJUR FROM A
yy
ccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its
ower Switch of the tool off
ower Switch of the tool off
electrical outlet
before performing any procedure in this section.
TO pREVENT SERIOUS INJURy
REVENT SERIOUS INJUR
REVENT SERIOUS INJUR :
DO NOT OpERATE WITH ANy GUARD DISABLED, DAMAGED, OR
yy
REMOVED.
Mounting Table for Use as Disc Sander
Mounting Table for Use as Disc Sander
NOTE: The Table (69) may be used as support
for both horizontal and vertical applications.
1. Insert the end of Table Bar (72)
with Pivot Indicator (70) into the
Bar Holder (74).
See Figure E.
Table (69)
Bar Holder (74)
pivot
Indicator (70)
Angle
Adjusting
Knob (75)
Flat Washer (26)
Tighten two Set
Screws (6)
Screws (6)
Screws (6)
Screws (6)
Table Bar (72)
Table Bar (72)
Table Bar (72)
Table Bar (72)
Table Bar (72)
Figure E
2. Insert free end of Table Bar (72) into two Mounting
Supports on bottom of Table (69). Tighten the
two Set Screws.
See Figure E on page 8.
3. Mount the Pivot Indicator (70) tab to the
Table (69) using a Hex Bolt (71), Flat Washer (26)
and Lock Washer (27).
See Figure F.
4. Mount Pivot Indicator (70) to the Bar Holder (74)
using the Angle Adjusting Knob (75)
and Flat Washer (26). Finger tighten.
See Figure E and Figure F.
5. Tighten all fasteners. Make sure the
Pivot Indicator (70) operates smoothly when
the Angle Adjusting Knob (75) is loosened.
Bolt (71),
Washer (26)
and Lock
Washer (27)
Figure F
6. Slide the Supporting Shaft (76) into Bar Holder (74).
Align the flat face of the Supporting Shaft with
Set Screws and tighten securely.
See Figure G.
7. Slide the Supporting Shaft (76) into the hole
on side of Machine Body (33) and tighten
Bolt (32).
See Figure D on page 7.
Supporting Shaft
Flat Side (76)
Bar Holder
(74)
Figure G