HP 409054-003 - Manual (Page 45)

Local port operation 45
To access the Scan dialog box, from the Main dialog box (" Accessing the Main dialog box " on page
28 ), click Setup>Scan. The Scan dialog box appears.
Adding servers to the scan list
NOTE: Servers will be scanned in the order they are selected. If you remove a server from the
Device Modify dialog box later, the change can affect a custom scan pattern.
1. From the Scan dialog box (" Setting up a scan pattern " on page 44 ), perform one of the following
actions:
o Select the checkbox beside each server to be added to the scan list.
o Double-click a server name or port.
You can select up to 100 servers from a list of all servers attached to the console switch. You can
display the list by either name or EID number by clicking the appropriate button. Selecting the
checkbox beside each server to be added to the scan list creates the scan list. The creation of a scan
list does not start the Scan mode. You must enable Scan mode through the Scan Enable checkbox on
the Commands dialog box (" Managing server tasks using the OSD " on page 48 ).
2. In the Time field, enter the number of seconds that should elapse (from 3 to 99) before the scan
moves to the next server in the sequence.