HotBrick VPN 800 - Manual (Page 14)

HotBrick Network Solutions
Page 10
9. Select LAN & DHCP from the menu. You will see a screen like the example below.
Figure 2-3: LAN & DHCP
10. Ensure these settings are suitable for your LAN:
• The default settings are suitable for many situations.
• See the following table for details of each setting.
11. Save your data, then go to Step 2, Installing the VPN 800/2 Firewall Router in your LAN.
Settings – LAN & DHCP
IP Address IP address for the VPN 800/2 Firewall Router, as seen from the local LAN.
Use the default value unless the address is already in use or your LAN is
using a different IP address range. In the latter case, enter an unused IP
Address from within the range used by your LAN.
Subnet Mask The default value 255.255.255.0 is standard for small (class "C") networks.
For other networks, use the Subnet Mask for the LAN segment to which the
VPN 800/2 Firewall Router is attached (the same value as the PCs on that
LAN segment).