HP N31.5 - Manual (Page 17)

17
repeat disc repeat track program clear program review program save index mode
on track
on disc MADRIGAL AUDIO LABORATORIES
repeat A>B preview program + program –
display
mode
10 8 6
7 9
5
elapsed time
time remaining
standby
REFERENCE
CD TRANSPORT
Nº 31.5
1 11 12 15
13 14
display
intensity
2 4 3
track index time
Front Panel
1 STANDBY
When the Nº31.5 is connected to AC power and the main power switch on
the rear panel is in the “|” position (see Rear Panel), pressing this button
takes the Nº31.5 out of “standby” mode and enables the front-panel con-
trols.
When the Nº31.5’s main power switch is first turned on (or when power is
restored after an interruption), the Nº31.5 will be ready to operate (that is, it
won’t be in standby mode).
Pressing standby again places the Nº31.5 into standby mode and disables
the front-panel controls. Pressing the open lid button will both switch the
unit out of standby and open the lid so you may load a disc.
While the Nº31.5 is in standby mode, the display is dark and the standby
LED flashes slowly. When the Nº31.5 is ready to operate (not in standby
mode), the standby LED remains lighted.
Note: When going into standby, the Nº31.5 deactivates its digital
outputs. With some digital processors, this may result in a low-
level “pop” on the audio outputs. (Mark Levinson digital
processors do not exhibit this problem.)
If your processor generates such a pop, and if you wish to
prevent this low-level “pop” from coming through your
system’s speakers or headphones, adjust your preamp’s
volume to its lowest level before placing the Nº31.5 into
standby.