Hisense Group KF-5002GWE - Manual (Page 10)

Components Introduction
REMOTE CONTROL UNIT
A A T. S E T T I N G T. S E T T I N G
C
A
A
Sensor
Testing the ambient temperature
of the remote control unit
LCD
Displaying the running condition.
Hi-power running button
Sleep button
Press the button, the appliance enter
sleep mode.
Flap
Up-down adjustment
Timer on/off button
Setting the time of appliance on/off.
Set/cancel timer button
Set or cancel the time of appliance
on/off.
A/C sensor button
Press the button if the remote
control unit is liable to be affected by
the heat resource, such as electric
blanket, radiator or sunlight, this will
use the sensor of indoor unit, the
symbol will appear on the LCD.
Transmitter
Transmitting signals to the indoor unit,
the symbol will appear on the top of
LCD.
On/Off button
Press the button to run, press again
to cease.
Temperature setting button
Press the button marked " "or
" " to increase or decrease
the temperature.
Mode selection button
Auto dehumidification
Fan cooling
Fan speed selection button
Reset button
Press the button after batteries are
loaded and indication appears on
LCD.
Sliding cover
Battery compartment
Remove the batteries in the remote control unit when it is not used for a long period.
Replace the batteries when the indication on the LCD of the remote control unit is faint, or the remote control unit cannot be set
or operated.
Properly dispose of used batteries.
Keep the remote control unit away from cold or hot air, sunlight or heat sources.
Contact the local distributor if the receiver in the appliance does not work in a room illuminated by fluorescent tubes.
Remote control unit must be used within its effective range or the timer and the temperature control will not function properly.
Control will fail if two of the same model appliances are installed in the same room.
If the remote control unit is fixed on the wall, press the On/Off button to ensure that the appliance is receiving a signal from the
device.
7
COMMONSENSE