Hisense Group KF-5002GWE - Manual (Page 26)

Appendix: Installation
8
2. INSTALLATION LOCATION
2.1 Indoor unit 2.2 Outdoor unit
!
!
WARNING
WARNING
Maintain the required space
around the appliance to
prevent overheat.
The location for installation of the appliance should not be in an
area with the following:
Di rect sunlight
H eat resource
Inflammable gas
Thick oil fog
The appliance should be installed in an area,
Where the inside space can be evenly conditioned, or
Which is strong enough for the appliance, or,
Having the shortest distance for the copper tubes and water
drain hose, and
Having desired space around the appliance for maintenance
and ventilation.(Figure 1)
Min. 5cm
Min. 5cm Min. 5cm
Figure 1
Tube arrangement
L H Added Refrigerant Provided Tube(M)
(g/m)
15 7 20 4
L: Maximum length of the tube connecting the indoor unit and the
outdoor unit.
H: The height difference between the indoor unit and the outdoor
unit.
Tube length(L)
Height difference(H)
Indoor unit
Outdoor
unit
* If the length of the tube is exceed 7m, an additional 20g/m of
refrigerant should be added per 1m.
Figure 2
The indoor unit should not be
installed below a height of 1.8m.
The outdoor unit should be installed away from the following:
Heat source and fan exhausting (Figure 3);
Director sunlight;
Figure 3
The outdoor unit should be installed in an area with,
Cool temperature;
Good ventilation;
Desired space for air inlet, outlet and maintenance
(Figure 4)
Air inlet
Min. 10cm
Min. 10cm
Min. 40cm
Min.10cm
Air inlet Ground
Valve side
Min. 25cm
Top obstacle
Air outlet
A
ir
o
u
tl
e
t
O
b
s
ta
c
le
Figure 4
2 Strong base (10x10cm concrete or alike). The appliance
should be placed not less than 10cm high (Figure 5).
Fix the base with firm bolts to reduce vibration and noise.
23
Air inlet
Concrete or alike
Firm bolts(4)
Min. 10cm
About 10cm
Abo
ut 4
0cm