HP 240A - Manual (Page 16)

16 2 HP-GL Mode Settings
Document Size
Sets the Client-Created document size.
Candidate values are shown below.
[Auto] (default)
[Output Size]
The size is the same as that set in [Output Size].
[A0] [A1] [A2] [A3] [A4] [A5] [B0] [B1] [B2] [B3] [B4] [B5]
Note
• If [Auto] is not selected, the [Auto Layout] setting switches to [Off].
• If [Auto] is not selected, the [Zoom Mode] setting switches to [Output Size].
Coord. Rotation
Sets the paper orientation for printing.
Candidate values are shown below.
[0] (default)
Paper orientation is set as landscape.
[90]
Paper orientation is set as portrait.
Gradation Mode
Sets the gradation for printing.
Candidate values are shown below.
[Grayscale] (default)
[Black Pen]
Auto Layout
Turns on or off the auto layout function.
Candidate values are shown below.
[On] (default)
[Off]
Note
• [On] only appears in the display when [Auto] is selected in [Document Size].
• When [Off] is selected, the [Zoom Mode] setting changes to [Output Size].
Palette Setup
Specifies the palette to be used.
Candidate values are shown below.
[Command] (default)
[Stored Jobs]
Quantity
„ Enter Quantity
Sets the number of copies to be printed.
You can set the number in a range from 1 to 250. The default value is 1.
Important
• The number of copies specified by the client is used when printing. After printing, that value can also be
changed on the printer control panel. But, if the number of copies was specified from a NetWare, or LPD
port, then the value set on the printer control panel cannot be changed after printing is finished.