HP 240A - Manual (Page 32)

32 3 Materials Related to HP-GL Mode
When [Output Size] Is Set to [Auto]
The size (A4, B5, or A5) of the paper set in the tray actually becomes the candidate value.
If A4, B5, or A5 size paper is not set in the tray, all A-sizes (A4 or A5) become the candidate
values and an error message prompting you to load paper in the tray appears on the control
panel.
When [Zoom Mode] Is Set to [Output Size]
If the output size which is the same as the document size is supported, select the paper of
the size which is the same as the document size.
If the document size is greater than any candidate paper size, select the paper of the largest
size.
If the document size is smaller than any candidate paper size, select the paper of the closest
size.
When [Zoom Mode] Is Set to [Coordinate Area]
Select the smallest paper that contains the effective coordinate area.
If the size of the effective coordinate area is larger than any candidate paper size, select the
paper of the largest size.
If the size of the effective coordinate area is smaller than any candidate paper size, select
the paper of the closest size.
Note
• When [Document Size] is set to a value other than [Auto], the output size set on the control panel is
assumed to be specified.
• When [Paper Tray] is set to [Auto], the size of the paper set in the tray is assumed to be specified. If the
size of the paper set in the tray is not supported, an error message appears to prompt you to set paper
of the supported size.