HP 240A - Manual (Page 9)

1.2 Default Settings 9
1.2 Default Settings
You can print in the following ways with the HP-GL and HP-GL/2 emulation modes set to
the default settings. The document data is enlarged or reduced (auto layout) to match the
size of the paper being used.
Document Size: Auto, Coord. Rotation: 0, Zoom Mode: Output Size,
Zoom: On
Note
• If necessary, you may change the default settings. See “2 HP-GL Mode Settings” (P. 13) for information
on changing settings.
Limits During Auto Layout Mapping
When the Hard Disk (Optional) Is Installed in the Printer
Print data is stored to the hard disk when Auto Layout is executed.
When the Hard Disk (Optional) Is not Installed in the Printer
Print data is stored to the Auto Layout memory when [auto layout function] is executed. The
initial capacity of the Auto Layout memory is 64 KB. Therefore, this printer cannot correctly
output auto layout if the print data received by the auto layout memory exceeds 64 KB. In
this case, change the size of the Auto Layout memory from the printer control panel. The
upper limit of the Auto Layout memory is 5,120 KB. The auto layout memory cannot accept
data larger than 5,120 KB.
We recommend installing the hard disk (optional) to this printer if you are going to use the
auto layout function.
Document size Output size
Printable area