Hilti SID/SIW 14-A/18-A - Manual (Page 19)

9. Troubleshooting
Fault Possible cause Remedy
The power tool doesn’t run. The battery is discharged or fitted
incorrectly. The battery must be heard to en-
gage with a double click or, respec-
tively, needs to be charged.
Electrical fault. Remove the battery from the power
tool and contact Hilti Service.
The on / off switch can’t be
pressed, i.e. the switch is
locked. The forward / reverse switch is in
the middle position (transport lock
engaged). Push the forward / reverse switch
to the left or right.
Running speed suddenly
drops considerably. The battery is discharged. Change the battery and recharge
the discharged battery.
The battery runs down more
quickly than usual. Battery condition is not optimal. Have battery condition diagnosed
by Hilti Service or replace with a
new battery.
The battery doesn’t engage
with an audible click. The retaining lugs on the battery
are dirty. Clean the retaining lugs and check
that the battery engages securely.
Contact Hilti Service if the problem
persists.
The power tool or the battery
become very warm. Electrical fault. Switch the power tool off imme-
diately, remove the battery and
contact Hilti Service.
The power tool has been
overloaded (application limits
exceeded). Use the right power tool for the job
(don’t use a low-powered tool for
heavy work).
10. Disposal
CAUTION
Improper disposal of the equipment may have serious consequences: The burning of plastic components
generates toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to
very high temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal
may permit unauthorized and improper use of the equipment. This may result in serious personal injury, injury
to third parties and pollution of the environment.
CAUTION
Dispose of defective batteries without delay. Keep them out of reach of children. Do not attempt to open or
dismantle batteries and do not dispose of them by incineration.
CAUTION
Dispose of the batteries in accordance with national regulations or return them to Hilti.
en
12