Hunter Fan 47350A - Manual (Page 13)

24
24 OPERATION
System Selector Switch
The System Selector switch on the front of the thermostat determines the operating
mode of the thermostat. You may select COOL, OFF, HEAT.
NOTE: Anytime you install or remove the thermostat from the wallplate,
slide the System Selector to the OFF position to prevent the possibility
of a rapid system On-Off.
Fan Switch
The Fan switch should normally be located in the AUTO position. The Fan will be
turned on along with normal operation of your system. In a normal gas or oil furnace,
the Fan will be turned on by your furnace after its warm-up delay. For electric heat, air
conditioning, and heat pump operation, the Fan will turn on with the system.
To run the Fan on continuously, slide the Fan switch to the ON position.
system
cool
heat
off
fan
on
auto
41659_model47350A_web.pmd
25
25 Temporary Manual Override
To temporarily change the current set temperature without affecting your program:
■ Press and hold for about 1 second to enter Manual
Override mode. When display flashes, you can
release the key.
■ Press again to change to your desired Set Tempera-
ture. Hold the key for 2 seconds to fast-advance the
Set Temperature.
■ Press to return to normal mode, or wait 5 seconds
for it to return automatically.
■ The current program number will flash to signify the
Temporary Override.
■ At the next program change time, the Temporary
Override is cancelled, and the next program tem-
perature becomes the setpoint temperature.
To end the Temporary Manual Override:
■ Press and wait for HOLD to display on the LCD.
■ Press again. This will return the set temperature to the current program set temperature.
or
hold
/return
TEMP COOL
PM
SA
3
hold
/return
TEMP COOL
SET TEMP
3
or