HandHeld Entertainment Quick Check PC600 - Manual (Page 31)

If you need to use a different wand (aperture), the Quick Check ® PC will accept
any Hand Held Products interchangeable wand. For scanning with a traditional
Pen Wand, the plastic support and wand tip must both be flat against the
scanning surface to maintain the proper scanning angle.
Note: When using a Pen Wand, both the tip of the wand and the plastic
alignment guide must be touching the surface. This provides the proper
scanning angle.
Note: When using the Mouse Wand, it must be flat against the surface.
As long as the wand is held against the surface properly, there is no “right” or
“wrong” way to hold the wand as long as a smooth scanning motion is achieved.
Experience is the best teacher for scanning technique. Consistent results are the
mark of an acceptable technique.
As a rule of thumb, it should take approximately one second to scan a symbol,
Quiet Zone to Quiet Zone. The larger the symbol, the faster you should move the
wand; the smaller the symbol, the slower you should move the wand. This
provides sufficient data points for accurate quality analysis without overloading
the data buffer.
You may need to practice until you're sure it takes about one second.
In addition to the data shown on the screen, there are a number of additional
detail screens that can be called up.
View Individual Scan Results
Once you have completed the required number of scans, you may review any
individual scan in the series. If you have saved and opened a file, you may also
review individual scans.
View the results of the previous scan (of a series).
Previous Scan
View, Previous Scan
View the results of the next scan (of a series).
Next Scan
View, Next Scan
23