HP 6200YL - Manual (Page 258)

----------------------------------------------------------------------
IPv6 Access Control Lists (ACLs)
Displaying ACL Configuration Data
ProCurve(config)# show access-list List-120
Access Control Lists
Name: List-120
Type: Extended
Indicates whether the ACL
is applied to an interface.
Applied: No
SEQ Entry
Remark Field (Appears if remark configured.).
10 Action: permit
Remark: Telnet Allowed
Src IP: 10.30.133.27 Mask: 0.0.0.0 Port(s): eq 23
Dst IP: 0.0.0.0 Mask: 255.255.255.255
Empty field indicates that
the destination TCP port
can be any value.
Port(s):
Proto : TCP (Established)
TOS : - Precedence: routine
Source Address
TCP Source Port
DSCP Codepoint and Precedence Data
Protocol Data
20 Action: deny (log)
Src IP: 10.30.133.1 Mask: 0.0.0.255 Port(s):
Dst IP: 0.0.0.0 Mask: 255.255.255.255 Port(s):
Proto : IP
TOS : - Precedence: -
30 Action: permit
Src IP: 0.0.0.0 Mask: 255.255.255.255 Port(s):
Dst IP: 0.0.0.0 Mask: 255.255.255.255 Port(s):
Proto : IP
TOS : - Precedence: -
Figure 8-31. Example of Listing an IPv4 Extended ACL
The show access-list < identifier > config command shows the same ACL data
as show access-list < identifier > but in the format used by the
show < run | config > commands to list the switch configuration. For example:
Port-1(config)# show access-list List-120 config
ip access-list extended "List-120"
10 remark "Telnet Allowed"
10 permit tcp 10.30.133.27 0.0.0.0 eq 23 0.0.0.0 255.255.255.255 precedence 0
established
20 deny ip 10.30.133.1 0.0.0.255 0.0.0.0 255.255.255.255 log
30 permit ip 0.0.0.0 255.255.255.255 0.0.0.0 255.255.255.255
exit
Figure 8-32. Example of an ACL Listed with the “Config” Option
8-82