Hampton Direct Wood Insert HI200 - Manual (Page 13)

HI200 Hampton Wood Cast Insert 13
INSTALLATION
6) Place ashlip over fan by fi tting it onto the fl ange on the fi rebox.
See Diagram 5 and 6.
Diagram 5
Diagram 6
Ashlip
Diagram 7
DO NOT ROUTE THE FAN POWER CORD
UNDER OR IN FRONT OF THE UNIT.
Do not turn the fan ON until your insert has reached
operating temperature or at least 30 minutes after
starting fi re.
8) Surround adjustments can be made up or down, loosen 4 bolts
shown on face of unit (Diagram 7) and adjust.
Surround can also be adjusted left or right, loosen 4 bolts shown in
Diagram 3 - adjust surround left or right and retighten bolts.
Check that gaps around door are even and door closes properly.
9) Completely slide unit into place - after all adjustments have been
made.
7) Install door and close with caution - adjustments may be
necessary.