Hampton Direct Wood Insert HI200 - Manual (Page 19)

HI200 Hampton Wood Cast Insert 19
MAINTENANCE
LATCH ADJUSTMENT
The door latch or door alignment may require adjustment as the door gasket material compresses after a few fi res. Removal of spacers will allow
the latch to be moved closer to the door frame, causing a tighter seal and the ability to raise or lower the latch assembly.
2) For Door Gasket Seal, remove the Latch Assembly from the unit by
undoing the outer 2 bolts.
1) Raise or lower the latch by undoing the inner 2 bolts. Adjust to
desired location and retighten the 2 bolts, make sure the door catch
closes freely and makes a good seal. Do a paper test to confi rm seal.
Latch
Assembly
Latch Assembly
removed from unit.
Mounting
Bracket
Latch
4) Re-secure Latch to Mounting Bracket using 2 bolts
Mounting
Bracket
Spacers
Latch Assembly re-assembled with
spacers removed.
5) Re-secure the Latch Assembly to the unit using 2 bolts.
Confi rm proper location of the door catch so that it closes tight,
freely.
3) Remove necessary amount of spacers sitting on the Mounting
Bracket.
Ensure an equal amount of spacers are removed from both
top and bottom.