Holland FW8 (XA-201) - Manual (Page 6)

6
FW8 (XA-201) FIFTH WHEEL
Trouble-Shooting Guide
Cause
PROBLEM: Difficult to couple to trailer (con’t.)
Remedy
4. The primary release handle is not
pulled out completely and hooked
on the notch in the casting.
5. Damaged, bent release handle.
6. Bent kingpin, damaged upper
coupler plate or improper use of
“lube plate.”
7. Attempting to couple too fast.
4. Slide the primary release handle forward,
pull the handle out, then slide it forward
again and hook it on the notch of the
top plate casting (see Figure 5).
5. Replace release handle using proper
release handle replacement kit for your
model FleetMaster fifth wheel. Contact
Holland for additional information.
6. Check the kingpin and upper plate
coupler as detailed in Holland Service
Bulletin XL-SB20. Remove any improperly
installed or improperly specified lube
plates. Refer to Holland Service Bulletin
XL-SB4 and XL-SB4a for lube plate
warnings.
7. Slowly back the tractor up to the
trailer. Pick up the trailer with the fifth
wheel. Stop. Then continue backing up
until the fifth wheel locks firmly to the
kingpin. Stopping helps prevent hitting
the kingpin too hard.
UNLOCK
NOTCH
LOCK NOTCH
1st
2nd
3rd
Figure 5
BACK INTO TRAILER
SLOWLY
➠ ➠ ➠
➠ ➠
DO NOT
BACK INTO
TRAILER FAST