Installation steps and start-up procedures, Study the installation diagram, Check fit – Hague Quality Water Intl WATERMAX LC100P User Manual

Page 18: Step 1, Tep 2

Advertising
background image

Installation Steps and Start-Up Procedures

We recommend that you have your local Hague dealer install and service this appliance.

Warning: Installation of this appliance must conform with state and local plumbing and electrical codes, laws,
regulations and the instructions provided with this appliance. Failure to install as instructed will void the product
warranty.

S

S

tep 1

Study the Installation Diagram

Study the overall installation diagram (See Figure 2) before proceeding, to familiarize yourself
with the general layout of the appliance.

tep 2

Check Fit

Ensure that the complete appliance will fit under the sink. Check all factory fittings

1

and tubing

connections. Be sure all locking clips are in place. See steps A through F and the illustrations
below for tube connection instructions.

A. Cut tube square

D. Insert the locking clip

Collet

Cut the tube square. It is essential that the outside
diameter be free of score marks and that burrs and sharp
edges be removed before inserting into fitting.

Insert the locking clip. The locking clip secures the collet in its
position to prevent an accidental disconnection of the tube.

B. Insert tube

E. Pull to check security

The fitting grips before it seals. Ensure that the tube is
pushed into the tube stop.

Pull on the tube to check that it is secure. Test the appliance
before leaving the site or before use.

C. Push up to tube stop

F. Disconnecting

Push the tube into the fitting to the tube stop. The collet
(gripper) has stainless-steel teeth that hold the tube firmly
in position while the O-Ring provides a permanent
leak-proof seal.

To disconnect, ensure that the appliance is depressurized.
Remove the locking clip. Push in the collet squarely against
face of the fitting. With the collet held in this position, the tube
can be removed. The fitting can then be re-used.

1

The

WaterMax

®

RO has been pressure tested. However, due to shipping vibrations, Hague recommends rechecking all

factory fittings upon installation.

WaterMax RO Owner’s Manual

11/11/2009

18

Advertising