15 installation – Hunter Fan 44250 User Manual

Page 14

Advertising
background image

The heating system selector and the F°/C° selector switches are located on the Printed
Circuit Board.

Heating system selector

The heating system selector is a switch on the Printed Circuit Board on the inside of the
thermostat. The switch is at “HG” position. Leave it in this position if you have a gas
furnace or an oil burner.
If you have an electric furnace, test to see whether the heat and fan come on as
expected. Leave the switch in the “HG” position. If the fan does not come on when the
thermostat calls for heat, change the switch position to “HE.”
The system selector has no effect in the cooling mode.
NOTE: “HG” position is for gas and most other systems. “HE” position is for certain
electric systems having a fan relay.

F°/C° selector (Fahrenheit/Centigrade)

Your thermostat is set for F° mode from the factory. In order to
change to C° mode, slide the switch to C° and press reset
button on front of the thermostat with a paper clip. The reset
button is located near the display.

NOTE: Unless reset button is pressed, the thermostat will
not change the mode.

14-15

Installation

Selector Switches

Connect Wires and Mount Thermostat Cover to Wall Plate

■ Match and connect the labeled wires to the appropriate coded terminal screws on the

mounting plate. (See Figure 3, 4.) Ignore any wires which may be present, but which were
not connected to the old thermostat.

HE

HG

C F

AJ514/41253 book p. 1-15 2/8/01 3:16 PM Page 14

Advertising