Hunter Fan 44250 - Manual (Page 16)

Programming
1 Remove mylar label covering display
window.
2 When the heating or cooling system is
actually operating, “HEAT” or “COOL”
will appear on the display.
3 If power is interrupted the batteries will
keep all programs.
4 If “LOW BATT” indicator appears on the
display replace the batteries.
Setting the Time and Day of Week
When you first install the two AA batteries, the thermostat automatically sets the day and
time to Monday, 12:00 a.m., shows the current room temperature and is programmed for 68°
in heat mode and 78° in cool mode. Press the reset button after installing new batteries.
The first data you should enter is the current time and day of week. As the keys are pressed,
the display will show the data being entered.
■ Initial read-out after pressing
reset button.
■ Current room temperature is 72°.
■ No indication of program number.
M T W TH F SA SU
SET TEMP HOLD TEMP
I 2 : 0 0 7 2 c
AM
PM
HEAT COOL ݗݘݙݚ
FILTER LO BAT
■ Press once. Temperature digits
disappear, show time set mode.
HOUR
M T W TH F SA SU
SET TEMP HOLD TEMP
I 2 : 0 0 7 2 c
AM
PM
HEAT COOL ݗݘݙݚ
FILTER LO BAT
EXAMPLE:
If the unit is
being
installed at
9:15 p.m.,
Saturday, to
set the
thermostat,
you would
press the
keys in the
shown
sequence.
16-17
AJ514/41253 book p. 1-15 2/8/01 3:16 PM Page 16