Henkel K-NP - Manual (Page 3)

Recommended Spare Parts
When it is critical to have continuous operation of this unit:
we suggest having the following spare parts on hand:
Heating Element Assembly
Thermostat Assembly
General Information
The model K-NP Keen oven is designed for storing filler material and 12 inch wire spools. The
unit has shelves that slide out for easy loading and unloading. Each shelf is fabricated from
perforated iron and is capable of holding 50 pounds of material. The lower section of the unit
consists of a perforated iron cradle used to store 12 inch wide spools. Mounted to the top of the
cabinet is a fitting that allows the unit to be purged with inert gas.
Safety Precautions
Read all instructions completely before attempting to operate this unit.
*** SAVE THESE SAFETY INSTRUCTIONS ***
DANGER
To reduce the risk of electrical shock, fire, or personal injury follow the guidelines below:
• Before connecting unit to a power source, be sure the voltage supplied is the same as that specified on
the name plate of the unit.
• Check outlet to ensure proper grounding of the electrical cable. Have a licensed electrician check the
A/C power outlet if you are not sure.
• Use this unit for its intended purpose as described by literature.
• Make sure power cord is located so that it will not be stepped on, tripped over, or otherwise subjected
to stress of heat, oil, or sharp edges. Do not close doors on the cord.
• To reduce the risk of damage to the electric plug and cord, disconnect by plug rather than by the cord.
• Do not use this unit if cord or plug is in poor condition. If it has been exposed to weather or immersed
in water, have a qualified serviceman inspect and replace parts as necessary.
• WARNING! NEVER HANDLE PLUG, CORD, OR UNIT WITH WET HANDS OR WHILE
STANDING IN WATER.
• Use special care when moving heavily loaded units.
- 3 -