Hunter Fan PH20-30A - Manual (Page 5)

 
 




 




 
 

 
1. Inspect the heater for damage that may have occurred
during shipment. Check against the packing list or
invoice for lost parts.
2. Inspect the controls for loose or missing hardware.
3. Inspect all lines, tubing, and fittings to see that they are
secure and free of breaks, kinks, or other damage.
 

!

"
.
The heater is normally installed within the compartment being heated. It can be
installed outside the compartment being heated by using a flexible heat duct to direct the
heated air into the compartment.
The heater must be shielded against direct contact from rain and snow.




Read all warning
tags supplied
with the heater.
Perform all duties
indicated on the
tags.


NOTE
A warranty card is packed with each heater leaving the factory. Attached
is a return postal card. It is the duty of the dealer to ensure that both the
owner's copy and the registration card are completed and the registration
card returned to Hunter Manufacturing Company. To be certain that you
obtain the benefits of the above warranty, this card should be returned
within 10 days from the date you purchased this equipment




The tilt switch is a safety device that stops heater operation in case the
vehicle overturns. Do not remove this switch or defeat its purpose.


CAUTION
The heater is designed for use in the horizontal position with the heat exchanger
exhaust outlet down. Other permissible positions are those which retain the
motor shaft in the horizontal plane. Operation in any other attitude voids all
warranties and may result in damage or rapid heater wear unless modified for
such use by Hunter Manufacturing Co