HONDA GXV610 - Manual (Page 8)

ENGLISH
Oil Change OIL FILTER
Change
UPPER
LIMIT
LOWER
LIMIT
OIL FILTER SOCKET
OIL DRAIN BOLT OIL FILLER CAP/DIPSTICK
OIL FILTER
FILTER MOUNTING BASE
SEAL
SEALING WASHER
8
Drain the engine oil, and retighten the drain bolt securely.
Use only a Honda Genuine oil filter or a filter of equivalent
quality specified for your model. Using the wrong filter, or a
non-Honda filter which is not of equivalent quality, may cause
engine damage.
Clean the filter mounting base, and coat the seal of the new oil
filter with clean engine oil.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw it in the trash, pour it on the ground,
or pour it down a drain.
Drain the used oil when the engine is warm. Warm oil drains
quickly and completely.
Use an oil filter socket, rather than a strap wrench, to avoid
striking and damaging the oil filter.
Remove the oil filter with an oil filter wrench and drain the
remaining oil into a suitable container. Dispose the used oil and
filter in a manner compatible with the environment.
Screw on the new oil filter by hand until the seal contacts the
filter mounting base, then use an oil filter wrench to tighten the
filter an additional 7/8 turn.
Oil filter tightening torque: 22 N·m (2.2 kgf·m , 16 lbf·ft)
Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap/dipstick, drain bolt and washer.
Allow the used oil to drain completely, then reinstall the drain
bolt and new washer, and tighten the drain bolt securely.
Oil filter tightening torque: 12 N·m (1.2 kgf·m , 9 lbf·ft)
Refill the crankcase with the specified amount of the
recommended oil (see page
). Reinstall the oil filler cap/
dipstick.
Start the engine, and check for leaks.
Stop the engine, and check the oil level as described on page .
If necessary, add oil to bring the oil level to the upper limit mark
on the dipstick.
Running the engine with a low oil level can cause engine
damage. This type of damage is not covered by the Distributor’s
Limited Warranty.
Reinstall the oil filler cap/dipstick securely.
With the engine in a level position, fill with the recommended oil
to the upper limit mark on the dipstick.
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
7.
7
7
GXV610 QYC4, QYF4 type and GXV620 QYC4 type
08/03/18 15:49:05 32Z6E600_008