Harbor Freight Tools 94515 - Manual (Page 14)

Page 14 SKU 94515 for technical questions, please call 1-800-444-3353.
installing the transparent panels
Panel Clips (46) are used to secure the Transparent Panels in place on the Green- 1.
house.
Remove the protective film from both sides of all panels. 2.
36
63/65
63 63
35
32
15a/15b
65
3. The Roof Panels (63) and the Roof Window Panels (65) will need to be placed as
shown in the illustrations above. The top edges of these panels need to be placed
up under the edge of the Crown (35) or the Window Support Beam (15a/15b).
One at a time, place each Transparent Panel (62–70) in its proper location on the 4.
Ceiling, Frame, and Door of the Greenhouse. Then, secure the Transparent Panel
in place, using the quantity and location of Panel Clips (46) as shown in the Panel
Installation Diagram, next page. Also, refer to the panel clip installation instructions
in step 6.
If the Door Top/Bottom Panel (70) does not fit properly, turn it 90° and try refitting 5.
it.
6. be careful, panel clip (46) ends may be sharp and may spring back!
To attach Panel Clips:
Place the two loose ends of the Clip into the groove in the frame. a.
Swing the center portion of the Clip up against the panel. b.
Two edges of the Clip swing under the edge of the panel and the center edge c.
holds the panel in place.