Harbor Freight Tools 94515 - Manual (Page 9)

Page 9 SKU 94515 for technical questions, please call 1-800-444-3353.
Assembling the Studs and braces
the 8 spots requiring a
Hold-down connector
(55) are marked with
a plus (+).
figure c
+
+
+
+
+
+
+
+
19
9 8
22
22
10
10
25
25
23
23
6
7
19
23
38
3
39
Viewed from other angle
1. Attach the Rear-Left and Rear-Right Studs (8, 9) to the outside of the Rear Floor
Plate (16) and Rear Brace (21). Slide a Hold-Down Connector (55) under the base
and over the Bolt at each Floor Plate (16) connection.
Attach the tops of the Rear Studs (8, 9) to the Rear-Right and Rear-Left Crown 2.
Beams (4, 5).
Attach a Side Stud (10) in the center of each side to the 3. outside of the frame with
an extra Bolt (43) in the slot. Slide a Hold-Down Connector (55) under the base
and over the Bolt at each bottom connection.
Attach a Side Diagonal Brace (22) from the hole on the Side Floor Plate (34) to the 4.
hole on the Side Ceiling Plate (36) on the inside as shown in figure c. The flange
on the Brace should face inward. Attach the center hole of the Brace to the Bolt
(43) in the center of the Side Stud (10). Attach the other Side Diagonal Brace (22)
to the other side in the same manner as the first.