Hearth and Home Technologies SMART-BATT-II User Manual
Page 9
9
SETTING
BUTTON
Figure 13. Setting Button/Child Proof Lockout
Setting
0
F/
0
C Scale
The factory setting for temperature is degrees Fahrenheit (
0
F).
To change this setting to degrees Centigrade (
0
C):
1. Remove the battery cover on the back of the transmitter
and locate the “setting button” at the top center of bat-
tery compartment (see Figure 13).
2. Push setting button and
0
F will begin flashing on the
LCD screen (see Figure 12, Location #4).
3. Push the DOWN button on the transmitter to change
0
F
to
0
C.
4. Push “setting button” on transmitter and Centigrade (
0
C)
degree readings will display on LCD screen.
5. Repeat this process to change back to Fahrenheit (
0
F)
reading, this time pushing the UP button. NOTE: LCD
screen will return to normal state if setting button is not
pushed within 15 seconds.
Setting Desired Room Temperature -
Thermo Operations
This remote control system can be thermostatically con-
trolled when the transmitter is in the THERMO mode.
(THERMO must be displayed on the screen). The transmit-
ter will “sense” the room temperature every two minutes
automatically turning the fireplace ON or OFF thermostati-
cally. To set the desired room temperature:
1. Press the MODE button to place the transmitter into
THERMO mode. THERMO ON or OFF will display.
2. Press the UP or DOWN button to select the desired
room temperature. The highest SET temperature is 99
0
F (32
0
C). The lowest SET temperature is 45
0
F (6
0
C).
NOTE: To prevent repeated thermo-cycling of the gas appli-
ance, the sensing unit in the transmitter will only activate
the remote receiver when the temperature change exceeds
2
0
F (1
0
C) above or below the SET (desired) temperature.
When the transmitter is in the THERMO mode, it should be
kept away from direct sources of heat such as fireplaces,
incandescent lighting and direct sunlight. Leaving the trans-
mitter in direct sunlight, for example, will cause it to read
the room temperature higher than it actually is.
Setting the Countdown Timer
This remote control system can operate with a built-in count-
down timer when the transmitter is in the ON or THERMO
modes (THERMO or ON must be displayed on the LCD
screen).
1. Press and release the TIMER/TIME button on the trans-
mitter. The word TIMER and 0:15 flash on the screen
(see Figure 12, Location #2).
2. Press the UP and DOWN button to begin advancing
through each of the countdown time options. Available
countdown times are 15 min, 30 min, 45 min, 1 hour, 1
hr 30 min, and each additional half hour up to nine hours.
3. To set the TIMER, press the SET button on the trans-
mitter. If the system is ON, it will remain on until the
“time” has expired. If the system is in the THERMO mode,
it will cycle on and off as the room temperature requires
until the “time” has expired.
NOTE: When the timer is used in the THERMO mode, the
THERMO operation will discontinue when the “time” has
expired.
Transmitter Low/Battery Indicator
An “X” outlined by a battery on the right side of the LCD
screen will appear when battery power has dropped signifi-
cantly. At this time, approximately two weeks of battery
power remains.
Receiver Batteries
The batteries must be replace once every season. It is rec-
ommended to replace at the beginning of the burn season
with 4AA alkaline batteries.
ROOM
ON
AM
F
FLAME
78
8 00
:
CP