Husky Baby Carrier - Manual (Page 14)

The buckle has two positions and
should be adjusted to fit your child
(Fig. D). Select the slot closest to, but
not under, the child.
WARNING: Do not use position two (2)
until child exceeds 50 pounds (22.6 kg)!
Remove the buckle, then rethread in
appropriate position. See page 28 for
buckle removal and rethreading
instructions.
25 24
Harness Height Adjustment Harness Height Adjustment
4 Thread the harness strap through the
appropriate harness slot (Fig. C).
5 Reattach harness strap to the yoke.
6 Repeat steps 3–5 for the second strap.
IMPORTANT: Do not remove HUGS system.
7 Pull harness adjuster strap to tighten the
harness.
8 Verify that all straps are threaded at the
same height and are not twisted.
Checking Harness Height:
1 Place child in restraint, then secure
harness (see pages 22–23).
2 Observe where the shoulder harness is
positioned on your child.
• Harness straps should be located in
the nearest slot at or above the child’s
shoulder.
3 If harness height is okay, continue using
child restraint without adjustment. If
harness height requires adjustment, refer
to Harness Height Adjustment below.
NOTE: Once the top slots become
necessary, your child may continue to use
the restraint until the top of the ears become
level with the top of the restraint shell, or the
child’s weight exceeds 80 pounds (36 kg).
Harness Height Adjustment
1 Loosen the harness, by lifting the
harness release lever while pulling the
shoulder straps forward as far as possible
(Fig. A).
2 From the rear of the child restraint,
unhook the shoulder harness from the
yoke (Fig. B).
3 Pull one strap through the shell and
cover, to the front of the restraint.
Forward Facing
Strap Height
B
C
A
Adjusting Buckle Position
1
2
D
P2219_R03.qxd 8/18/2004 11:05 AM Page 26